Introduction
With the AgroVision Service Group Monitor (SGM) you can setup any type of service group system. This is a one-time setup, but if you change your service group setup, then it is of course also possible to change it in here.
- To get the SGM to match the service groups you already have setup in PigVision you should note the numbers marked with no. 1 to 5 in the picture below. You find this information in “General”, “Setup”, “Service groups”. This information is what you need to setup the SGM.
- In the following setup of the SGM in MyAgroVision we will focus the service group 1 with start date 04/01/2021 (the two red boxes in the picture above).
- Log in to MyAgroVision
- After getting into MyAgroVision find the ServiceGroupMonitor (7) and click the gears icon (8) to start the setup, see picture below:
- Enter your numbers 1,2,4 and 5 from your service groups setup in PigVision in the SGM setup window, like this:
- In “First weaning date” enter Start date (3). When done click the “Preview”.
- Scroll down in the preview until you find a “SG No.” (in the red box on the picture below) matching your Service group start number (1) and is close to matching your service group start date. You only need to look in the column “SG service from” (9).
- In the example below the date for “SG services from” is 2021-01-03 and that is one day off, so we move the “First weaning date” from 2021-01- 04 to 2021-01-05.
- When you have finished the setup, it takes a day before you can see the service group report.